16″ Tailgate Mount Third Brake Light

Description

The following third brake light is designed to be mounted on the rear tail gate or lift gate of a variety of different vehicles in the 1990s and 2000s.   This light measures is 16″ x 2.06″ and has a black case with a red lens.   This light is designed to be mounted on a flat surface with the aid of adhesive tape and two mounting screws on either side of the light. This light has a red lens. If you are not sure if this is light is the appropriate replacement for your vehicle please follow our online instructions.  This light is available with a red, clear, and black lens.  All versions light up red when you step on the brake.

In order to decipher which light you will need you will have to examine your current spoiler light and see if it is mounted to your spoiler with tabs or without. If you don’t see any tabs then it is most likely mounted with adhesive tape.

Specifications:

• 16″ Approximate Length
• 2.06″ Approximate Width
• 3M Tape Mount (Included)
• 2 Screws Mount (Optional)
• Red, Clear, and Black Lens Available (All Versions Light up Red)
• Center Wire
• 30 LEDS
• SAE/DOT Approved

Installation Instructions/
1. Clean mounting surface area thoroughly before mounting.
2. The light is designed to be mounted in the high center of the vehicles roof. Make sure to locate the correct position by measuring it and marking the area with an erasable marker. WARNING/ Make SURE to use a marker that is not permenate and will damage your paint!
3. Remove the cover film of the double side adhesive tape, carefully make placement and firmly apply pressure. Allow 24 hours to firmly set.
4. Wiring/ One negative wire to metal ground, one positive wire to brake light. If brake lamp and rear lamp are sharing the same bulb, please make sure the positive wire of 3rd brake lamp is connected to the right positive electrode.
5. 3rd brake lamp will not flash when turn signals are on. For those vehicles with combined brake and turn signal, p lease try to connect the positive wire of our unit to the front brake wire.